melanotan-2 comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Updated 2026-04-23. Numbers and descriptions here follow the published literature rather than marketing material.
Routine characterisation relies on reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, using a C18 column and a water-acetonitrile gradient containing trifluoroacetic acid. Electrospray ionisation mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidised by-products that co-elute poorly. Sequence and stereochemistry require additional work, such as peptide mapping or amino acid analysis, because a chromatographic purity figure alone does not distinguish a diastereomer from the target peptide. Independent testing of research-grade material frequently shows measured content below the stated label, so a certificate of analysis is best read together with the method that produced it.
Melanotan-2 is handled in the laboratory as a lyophilised powder that dissolves readily in water, dimethyl sulfoxide and dimethylformamide, with limited solubility in ethanol. Stock solutions prepared in an organic solvent often precipitate when diluted into aqueous buffer, so gradual dilution with mixing is standard practice. The peptide carries a tryptophan residue and a histidine residue, both sensitive to oxidation and to alkaline conditions. Working solutions are therefore kept near neutral to slightly acidic pH, protected from light, and consumed within the same working session whenever that is practical.
Solid peptide kept dry at minus twenty degrees Celsius, shielded from light and moisture, is generally considered stable for extended periods. Solutions are divided into single-use aliquots and held at minus twenty or minus eighty degrees Celsius, because repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. Hydrolysis of the backbone and oxidation of tryptophan are the principal degradation routes in aqueous solution, and both accelerate at ambient temperature. Hygroscopic uptake after a vial is opened can also shift the actual mass weighed, which affects any concentration calculated from it.
The compound emerged from research programs in the 1980s that examined analogues of alpha-melanocyte-stimulating hormone for pigmentation and photoprotection. Investigators modified the native sequence to extend activity duration and potency. A related analogue, afamelanotide, was developed within the same broad line of inquiry and eventually gained approval in certain jurisdictions for a rare light-sensitivity condition. Melanotan-2 itself did not progress through the same regulatory route and has no approved therapeutic indication.
Melanocortin receptors comprise five subtypes with distinct tissue distributions and functions. Melanotan-2 is described in the literature as a non-selective agonist that engages several of these subtypes, including MC1R, MC3R, MC4R, and MC5R. MC1R is the subtype most directly linked to melanin production in skin cells. Because the compound is not subtype-selective, its observed effects in experimental settings are generally attributed to activity across multiple receptor pathways rather than to a single target.
Melanotan-2 is a synthetic linear peptide built from seven amino acids arranged in a short chain. Its sequence is commonly written as Ac-Nle-Asp-His-D-Phe-Arg-Trp-Lys-NH2, which includes a modified N-terminus and an amidated C-terminus. The molecule belongs to the melanocortin family and acts as a receptor agonist. Structural features such as the D-phenylalanine residue and the Nle substitution are associated with increased stability against enzymatic degradation relative to the natural parent peptide.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised material may be hygroscopic |
| Solubility class | Soluble in water, DMSO and DMF | Dilution into aqueous buffer can cause precipitation |
| Storage of solid | Minus 20 degrees C, desiccated, dark | Aliquot to limit repeated opening of the vial |
| Storage of solution | Minus 20 to minus 80 degrees C, aliquoted | Avoid repeated freeze-thaw cycles |
| Identity method | Reversed-phase HPLC with mass spectrometry | Retention time and mass are checked together |
The material is commonly handled as a lyophilized powder in sealed vials. The solid dissolves readily in water and in polar organic solvents, producing a clear solution after reconstitution. Light, heat and repeated freeze-thaw cycles are the concerns most often raised in handling guidance, because peptide bonds and the constrained ring can degrade. Working solutions are generally prepared fresh, and material left in solution is treated as less stable than the dry form. These properties shape how laboratories store and aliquot reference material.
Identity and purity are assessed mainly by reversed-phase high-performance liquid chromatography with ultraviolet detection, often paired with mass spectrometry. Retention time supports identity, while the mass spectrum confirms the molecular weight of the intact peptide. Purity is frequently reported as a percentage of total peak area, a figure that depends on the wavelength, column and gradient used. Impurity profiling may also look for truncated sequences, oxidised forms and residual counterions. Amino acid analysis and peptide mapping provide orthogonal confirmation when required.
Melanotan-2 is a synthetic peptide designed as an analog of alpha-melanocyte-stimulating hormone, a signaling molecule produced in the pituitary and skin. Its structure is a linear chain of seven amino acids that folds into a ring through an internal lactam bridge joining two side chains. The compound is sometimes written as MT-II or MEL-2 in informal and commercial contexts. It belongs to the melanocortin peptide family, a group of short signaling molecules that share a conserved core sequence recognized by melanocortin receptors.
Two structural changes distinguish the synthetic peptide from the natural hormone. A norleucine residue replaces methionine at one position, and a D-configured phenylalanine replaces the natural L-form at another. Both substitutions slow enzymatic breakdown, which extends the molecule's persistence relative to the parent hormone. The lactam bridge further constrains the backbone into a stable conformation. These features are standard design strategies in peptide chemistry and are not unique to this compound; they appear across many research peptides built for improved stability.
The compound was developed in the late 1980s and early 1990s by academic researchers investigating melanocortin signaling and pigmentation. Early work explored whether synthetic analogs could reproduce effects of the natural hormone under controlled conditions. The molecule never advanced through the full regulatory pathway required for approval as a medicine. From the mid-2000s onward it appeared in unregulated consumer markets, often distributed through informal channels. That gap between research origins and commercial availability shapes how the compound is discussed today.
Handling guidance for melanotan II follows general practice for small synthetic peptides rather than a product-specific monograph. Lyophilized powder is typically kept at minus twenty degrees Celsius or colder, protected from light and moisture, because warmth and humidity accelerate degradation. Once reconstituted, solutions are usually refrigerated and used within a short window, as hydrolysis and microbial growth both become concerns. Repeated freeze-thaw cycles are generally avoided. These conventions come from laboratory peptide chemistry and not from formal stability studies on this specific compound.
Analytical confirmation of identity relies on mass spectrometry, most often coupled to liquid chromatography. Reversed-phase high-performance liquid chromatography separates the peptide from related impurities and provides a purity estimate based on peak area. Electrospray ionization mass spectrometry then confirms the expected molecular mass, while tandem mass spectrometry can map the fragment sequence. For research-grade material, these two techniques together form the standard minimum. Purity figures reported by vendors are frequently not traceable to an independent laboratory.
Melanotan-2, also written Melanotan II, is a synthetic cyclic heptapeptide designed as an analogue of alpha-melanocyte-stimulating hormone. Its sequence is Ac-Nle-cyclo[Asp-His-D-Phe-Arg-Trp-Lys]-NH2, and the lactam bridge between the aspartate and lysine side chains constrains the peptide into a ring. This structural change increases receptor affinity and metabolic stability relative to the native hormone. The compound was created in the 1980s as a research tool for studying pigmentation biology.
Melanocytes are the pigment-producing cells of the skin, and they carry melanocortin-1 receptors on their surface. When the receptor is activated, cyclic adenosine monophosphate rises inside the cell and raises the activity of enzymes such as tyrosinase, which increases melanin output. Melanotan-2 binds melanocortin-1 receptors in vitro and in animal models, and this binding is generally described as the basis for the tanning effect. Other receptors account for different effects: melanocortin-4 receptors contribute to appetite and erectile signalling, while melanocortin-3 and melanocortin-5 receptors contribute to energy balance and exocrine function.
== External links == Wood Library-Museum of Anesthesiology The most comprehensive educational, scientific and archival resources in anesthesiology. "Chloroform: The molecular lifesaver" An article at University of Bristol providing interesting facts about chloroform. Australian & New Zealand College of Anaesthetists Monitoring Standard Royal College of Anaesthetists Patient Information page Turning the Pages: a virtual reconstruction of Hanaoka's Surgical Casebook, c. 1825. From the U.S. National Library of Medicine (in German) Die Geschichte der Anästhesie. "Anesthesia as a specialty: Past, present and future" Presentation by Prof. Janusz Andres.
== Biography == Houghten received his PhD in organic chemistry from the University of California, Berkeley in 1975. He had previously received a BS in chemistry from California State University, Fresno and an M.S. in chemistry from Berkeley. He held a postdoctoral fellowship at the University of California, San Francisco, then an assistant professorship at Mount Sinai School of Medicine, City University of New York, and then joined the Scripps Research Institute, La Jolla, working with Richard Lerner. Houghten branched out to the business world in the 1980s, forming Multiple Peptide Systems in 1986, the Torrey Pines Institute for Molecular Studies (TPIMS) in 1988 and Houghten Pharmaceuticals, Inc. in 1990.
==== Urinary system ==== The urinary system is the part of the excretory system that removes waste in the form of urine, comprising the kidneys, ureters, bladder, and the urethra. Other purposes of the urinary system include the regulation of blood volume and blood pressure; the control of electrolyte and metabolite levels; and the regulation of blood pH. Each kidney consists of functional units called nephrons. Following filtration of blood and further processing, the ureters carry urine from the kidneys into the urinary bladder. During urination, the urethra carries urine out of the bladder through the penis or vulva. The female and male urinary system are very similar, differing only in the length of the urethra.
MDMA - Isomer Design MDMA - PsychonautWiki MDMA - Erowid MDMA - PiHKAL - Erowid MDMA - PiHKAL - Isomer Design A Multi-Site Phase 3 Study of MDMA-Assisted Therapy for PTSD (MAPP2) "MDMA Facts and Statistics". National Institute on Drug Abuse. 15 June 2020.
Sources: en.wikipedia.org
Mikhail Semyonovich Tsvet, also spelt Tsvett, Tswett, Tswet, Zwet, and Cvet (Russian: Михаил Семёнович Цвет; 14 May 1872 – 26 June 1919) was a Russian-Italian botanist who invented chromatography. His last name is Russian for "colour" and is also the root word of "flower."
Christianity and Druze are Abrahamic religions that share a historical traditional connection with some major theological differences. The two faiths share a common place of origin in the Middle East and are both monotheistic. Christian and Druze communities share a long history of interaction dating back roughly a millennium, particularly in Mount Lebanon. Over the centuries, they have interacted and lived together peacefully, sharing common social and cultural landscapes, despite occasional exceptions. Moreover, Druze beliefs, scriptures and teachings incorporate several elements from Christianity. Historically, the relationship between the Druze and Christians has been characterized by harmony and peaceful coexistence. The divisions within society mainly ran along the lines of class distinction between elites and commoners (alahi) instead of along religious divides in places like Mount Lebanon. Amicable relations between the two groups prevailed throughout history, with the exception of some periods, including 1860 Mount Lebanon civil war. In the Levant region, the conversion of Druze to Christianity was a common practice. Throughout history, there have been instances where prominent members of the Druze community, including some of Shihab dynasty members, as well as the Abi-Lamma clan, embraced Christianity. Bashir Shahib II even presented himself as Druze to Druze populations and as Christian to Christian populations.
Unicellular organisms can move in order to find food or escape predators. Common mechanisms of motion include flagella and cilia, and the projection of pseudopodia in amoeboid movement. Cells in multicellular organisms can move during processes such as wound healing, the immune response, and cancer metastasis. In wound healing in animals, white blood cells move to the wound site to kill the pathogens causing infection. Cell motility involves many receptors, crosslinking, bundling, binding, adhesion, motor and other proteins. The process is divided into three steps: protrusion of the leading edge of the cell, adhesion of the leading edge and de-adhesion at the cell body and rear, and cytoskeletal contraction to pull the cell forward. Each step is driven by physical forces generated by unique segments of the cytoskeleton.
Sources: en.wikipedia.org
Purity is normally stated as an area percentage from high-performance liquid chromatography, for example ninety-five or ninety-eight percent. That figure describes the proportion of ultraviolet-absorbing material eluting as the main peak. It says nothing about water content, counterions, residual solvents or mass fraction of the peptide itself.
Peptides are commonly isolated as acetate or trifluoroacetate salts, and the counterion contributes to total mass. Two vials with identical peptide content can therefore differ in weight and in measured response. Residual trifluoroacetate is also relevant in cell-based work because it can influence membrane behaviour.
Degradation products are often closely related to the parent molecule, making them hard to resolve with a single method. Counterion variability adds a further source of scatter between laboratories. Because no pharmacopoeial monograph exists for melanotan-2, groups rely on method-specific validation rather than a shared reference standard.
No. Melanotan-2 is manufactured synthetically. The naturally occurring peptide in the same family is alpha-melanocyte-stimulating hormone, which the body produces as part of normal endocrine and neural signalling.