regulatory status raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
Reviewed 2026-06-24. Anything still debated is marked as such rather than presented as settled.
Melanotan-2 is handled in the laboratory as a lyophilised powder that dissolves readily in water, dimethyl sulfoxide and dimethylformamide, with limited solubility in ethanol. Stock solutions prepared in an organic solvent often precipitate when diluted into aqueous buffer, so gradual dilution with mixing is standard practice. The peptide carries a tryptophan residue and a histidine residue, both sensitive to oxidation and to alkaline conditions. Working solutions are therefore kept near neutral to slightly acidic pH, protected from light, and consumed within the same working session whenever that is practical.
Solid peptide kept dry at minus twenty degrees Celsius, shielded from light and moisture, is generally considered stable for extended periods. Solutions are divided into single-use aliquots and held at minus twenty or minus eighty degrees Celsius, because repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. Hydrolysis of the backbone and oxidation of tryptophan are the principal degradation routes in aqueous solution, and both accelerate at ambient temperature. Hygroscopic uptake after a vial is opened can also shift the actual mass weighed, which affects any concentration calculated from it.
Routine characterisation relies on reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, using a C18 column and a water-acetonitrile gradient containing trifluoroacetic acid. Electrospray ionisation mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidised by-products that co-elute poorly. Sequence and stereochemistry require additional work, such as peptide mapping or amino acid analysis, because a chromatographic purity figure alone does not distinguish a diastereomer from the target peptide. Independent testing of research-grade material frequently shows measured content below the stated label, so a certificate of analysis is best read together with the method that produced it.
Pharmacologically, melanotan-2 behaves as a non-selective agonist across the melanocortin receptor family. Binding at MC1R on dermal melanocytes promotes eumelanin synthesis, which underlies the tanning response described in early human work. Activity at the centrally expressed MC4R receptor is associated with reported effects on appetite and erectile function. Because the peptide does not discriminate strongly among receptor subtypes, attributing any single observed effect to one receptor pathway is generally not possible without selective antagonists or receptor knockout models.
Research interest has centred on photoprotection and pigmentation, with a smaller body of work on appetite and sexual function. Published human data remain limited to small, frequently uncontrolled studies, and the compound has never received marketing approval from a national medicines regulator. Most laboratory work treats it as a pharmacological tool for probing melanocortin signalling in cell culture or animal models. Whether pigmentation changes observed in people translate into measurable protection against ultraviolet-induced DNA damage remains an open question.
Melanotan-2 is a synthetic cyclic heptapeptide designed as an analogue of alpha-melanocyte-stimulating hormone, the naturally occurring peptide involved in pigmentation signalling. Its sequence is conventionally written as Ac-Nle-cyclo[Asp-His-D-Phe-Arg-Trp-Lys]-NH2, with a lactam bridge joining the aspartate side chain to the lysine side chain. The empirical formula is C50H69N15O9 and the monoisotopic mass lies near 1023.5 daltons. N-terminal acetylation and the D-configured phenylalanine both increase resistance to enzymatic breakdown compared with the parent hormone.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised material may be hygroscopic |
| Solubility class | Soluble in water, DMSO and DMF | Dilution into aqueous buffer can cause precipitation |
| Storage of solid | Minus 20 degrees C, desiccated, dark | Aliquot to limit repeated opening of the vial |
| Storage of solution | Minus 20 to minus 80 degrees C, aliquoted | Avoid repeated freeze-thaw cycles |
| Identity method | Reversed-phase HPLC with mass spectrometry | Retention time and mass are checked together |
Melanotan-2 has not received marketing authorisation from major regulatory agencies for any therapeutic indication. Several jurisdictions classify it as a prescription-only medicine or a controlled substance when supplied for human use. Because approved products do not exist, material sold online usually sits outside pharmaceutical supply chains and formal quality oversight. Regulators have issued public notices describing the compound as unapproved. Enforcement varies, and the legal position differs between countries, which complicates any single general statement about its status.
Scientific discussion of Melanotan-2 spans pharmacology, dermatology, and public-health literature. Laboratory studies examine its receptor binding and cellular effects, while clinical reports describe outcomes observed after unregulated use. These two bodies of work differ in rigour and intent. Peer-reviewed trials of the compound as a medicine are limited, so much of the available information comes from case reports and surveillance data. Authors frequently note the gap between experimental findings and real-world use.
Reported observations after unregulated use include shifts in skin pigmentation and, in some accounts, unintended changes to moles and other lesions. Whether these outcomes are causally linked to the compound, and how often they occur, remain open questions because controlled data are scarce. The absence of standardised dosing and verified product purity complicates interpretation. Researchers have called for better surveillance and analytical characterisation of samples obtained outside regulated channels. Conclusions drawn from anecdotal evidence should be treated as provisional.
Melanotan-2 is a synthetic peptide designed as an analog of alpha-melanocyte-stimulating hormone, a signaling molecule produced in the pituitary and skin. Its structure is a linear chain of seven amino acids that folds into a ring through an internal lactam bridge joining two side chains. The compound is sometimes written as MT-II or MEL-2 in informal and commercial contexts. It belongs to the melanocortin peptide family, a group of short signaling molecules that share a conserved core sequence recognized by melanocortin receptors.
Two structural changes distinguish the synthetic peptide from the natural hormone. A norleucine residue replaces methionine at one position, and a D-configured phenylalanine replaces the natural L-form at another. Both substitutions slow enzymatic breakdown, which extends the molecule's persistence relative to the parent hormone. The lactam bridge further constrains the backbone into a stable conformation. These features are standard design strategies in peptide chemistry and are not unique to this compound; they appear across many research peptides built for improved stability.
The compound was developed in the late 1980s and early 1990s by academic researchers investigating melanocortin signaling and pigmentation. Early work explored whether synthetic analogs could reproduce effects of the natural hormone under controlled conditions. The molecule never advanced through the full regulatory pathway required for approval as a medicine. From the mid-2000s onward it appeared in unregulated consumer markets, often distributed through informal channels. That gap between research origins and commercial availability shapes how the compound is discussed today.
The service-entry deadline of summer 1980, announced by Minister of Civil Aviation Boris Bugayev in 1977 had passed, however, and the Il-86 missed the Moscow Olympics in the summer of 1980. Overall development of the Il-86 occupied over a decade. The length of this period was due to the sensitivity of the airliner's configuration, problems with its powerplant, prolonged avionics development and the low priority of civil as opposed to military aircraft. In its earlier stages, the Il-86 programme was also held back by hopes of US airliner imports. Certificating the Il-86 to the very demanding set of Soviet and Comecon standards called NLGS-2 also delayed progress; it was the first Soviet aircraft to undergo a full certification programme since certification was introduced in the USSR in 1967 and became mandatory five years later.
== 20th Century == 1901: Florence Bascom became the first female geologist to present a paper before the Geological Survey of Washington. 1903: Marie Curie became the first woman to win the Nobel Prize, awarded in Physics, and went on to also win the Nobel Prize in Chemistry. She performed pioneering research in radioactivity, and discovered two elements (polonium and radium). 1912: Henrietta Swan Leavitt studied the bright-dim cycle periods of Cepheid stars, then found a way to calculate the distance from such stars to Earth. 1924: Florence Bascom became the first woman elected to the Council of the Geological Society of America. 1925: Florence Sabin became the first woman elected to the National Academy of Sciences. 1928: Alice Evans became the first woman elected president of the Society of American Bacteriologists. 1936: Edith Patch became the first female president of the Entomological Society of America.
In MASS, the sample is spun at several kilohertz around an axis that makes the so-called magic angle θm (which is ~54.74°, where 3cos2θm-1 = 0) with respect to the direction of the static magnetic field B0; as a result of such magic angle sample spinning, the broad chemical shift anisotropy bands are averaged to their corresponding average (isotropic) chemical shift values. Correct alignment of the sample rotation axis as close as possible to θm is essential for cancelling out the chemical-shift anisotropy broadening. There are different angles for the sample spinning relative to the applied field for the averaging of electric quadrupole interactions and paramagnetic interactions, correspondingly ~30.6° and ~70.1°. In amorphous materials, residual line broadening remains since each segment is in a slightly different environment, therefore exhibiting a slightly different NMR frequency. Line broadening or splitting by dipolar or J-couplings to nearby 1H nuclei is usually removed by radio-frequency pulses applied at the 1H frequency during signal detection. The concept of cross polarization developed by Sven Hartmann and Erwin Hahn was utilized in transferring magnetization from protons to less sensitive nuclei by M.G. Gibby, Alex Pines and John S. Waugh. Then, Jake Schaefer and Ed Stejskal demonstrated the powerful use of cross polarization under MAS conditions (CP-MAS) and proton decoupling, which is now routinely employed to measure high-resolution spectra of low-abundance and low-sensitivity nuclei, such as carbon-13, silicon-29, or nitrogen-15, in solids.
==== Beta-blockers ==== Beta-blockers act as competitive antagonists that block the effects of catecholamines at beta-adrenergic receptor sites, resulting in reduced rate and force of contraction of the heart, as well as reduced peripheral vascular resistance.
Sources: en.wikipedia.org
==== Quantum dot only solar cells ==== Aromatic self-assembled monolayers (SAMs) (such as 4-nitrobenzoic acid) can be used to improve the band alignment at electrodes for better efficiencies. This technique has provided a record power conversion efficiency (PCE) of 10.7%. The SAM is positioned between ZnO–PbS colloidal quantum dot (CQD) film junction to modify band alignment via the dipole moment of the constituent SAM molecule, and the band tuning may be modified via the density, dipole and the orientation of the SAM molecule.
==== MHC class II molecule stabilization - chaperonal function ==== The low pH of lysosomes could cause denaturation or proteolysis of MHC class II molecules. HLA-DM binding to MHC stabilizes and protects from degradation, by covering hydrophobic surfaces. Antigen degradation could also ensue, resulting in an inability to bind to the peptide-binding groove. Thus, HLA-DM is needed to protect proteins against the lysosomal environment.
Epithelial tissue is composed of closely packed cells, bound to each other by cell adhesion molecules, with little intercellular space. Epithelial cells can be squamous (flat), cuboidal or columnar and rest on a basal lamina, the upper layer of the basement membrane, the lower layer is the reticular lamina lying next to the connective tissue in the extracellular matrix secreted by the epithelial cells. There are many different types of epithelium, modified to suit a particular function. In the respiratory tract there is a type of ciliated epithelial lining; in the small intestine there are microvilli on the epithelial lining and in the large intestine there are intestinal villi. Skin consists of an outer layer of keratinized stratified squamous epithelium that covers the exterior of the vertebrate body. Keratinocytes make up to 95% of the cells in the skin. The epithelial cells on the external surface of the body typically secrete an extracellular matrix in the form of a cuticle. In simple animals this may just be a coat of glycoproteins. In more advanced animals, many glands are formed of epithelial cells.
Sources: en.wikipedia.org
=== EC 2.9: selenium transferases === EC 2.9 includes enzymes that transfer selenium-containing groups. This category only contains two transferases, and thus is one of the smallest categories of transferase. Selenocysteine synthase, which was first added to the classification system in 1999, converts seryl-tRNA(Sec UCA) into selenocysteyl-tRNA(Sec UCA).
== Law of cosines for dihedral angle == Given 3 faces of a polyhedron which meet at a common vertex P and have edges AP, BP and CP, the cosine of the dihedral angle between the faces containing APC and BPC is:
Cleavage at the reactive site results in entrapment of the thrombin protease, with movement of the cleaved reactive site loop together with the bound protease, such that the loop forms an extra sixth strand in the middle of beta sheet A. This movement of the reactive site loop can also be induced without cleavage, with the resulting crystallographic structure being identical to that of the physiologically latent conformation of plasminogen activator inhibitor-1 (PAI-1). For this reason the conformation of antithrombin in which the reactive site loop is incorporated uncleaved into the main body of the protein is referred to as latent antithrombin. In contrast to PAI-1 the transition for antithrombin from a normal or native conformation to a latent conformation is irreversible. Native antithrombin can be converted to latent antithrombin (L-antithrombin) by heating alone or heating in the presence of citrate. However, without extreme heating and at 37 °C (body temperature) 10% of all antithrombin circulating in the blood is converted to the L-antithrombin over a 24-hour period. The structure of L-antithrombin is shown in Figure 6. The 3-dimensional structure of native antithrombin was first determined in 1994. Unexpectedly the protein crystallized as a heterodimer composed of one molecule of native antithrombin and one molecule of latent antithrombin.
Sources: en.wikipedia.org
Purity is normally stated as an area percentage from high-performance liquid chromatography, for example ninety-five or ninety-eight percent. That figure describes the proportion of ultraviolet-absorbing material eluting as the main peak. It says nothing about water content, counterions, residual solvents or mass fraction of the peptide itself.
Peptides are commonly isolated as acetate or trifluoroacetate salts, and the counterion contributes to total mass. Two vials with identical peptide content can therefore differ in weight and in measured response. Residual trifluoroacetate is also relevant in cell-based work because it can influence membrane behaviour.
Degradation products are often closely related to the parent molecule, making them hard to resolve with a single method. Counterion variability adds a further source of scatter between laboratories. Because no pharmacopoeial monograph exists for melanotan-2, groups rely on method-specific validation rather than a shared reference standard.
It is a synthetic cyclic heptapeptide analogue of alpha-melanocyte-stimulating hormone, containing seven amino acids with a lactam ring and a D-configured phenylalanine residue. It is supplied as a lyophilised powder for laboratory research.